The tradition & historical record
4 min read · 9 sourcesDirt track racing is a form of motorsport held on clay or dirt surfaced banked oval racetracks. Dirt track racing started in the United States before World War I and became widespread during the 1920s and 1930s using both automobiles and motorcycles, spreading throughout Japan and often running on horse racing tracks. There are a myriad of types of race cars used, from open wheel Sprint cars and Modifieds to stock cars. While open wheel race cars are purpose-built racing vehicles, stock cars (also known as fendered cars) can be either purpose-built race cars or street vehicles that have been modified to varying degrees. There are hundreds of local and regional racetracks throughout the United States and also throughout Japan. The sport is also popular in Canada, Mexico, Argentina, Brazil, Chile, Australia, New Zealand, South Africa and the United Kingdom. 1
Racetrack
A dirt track's racing surface may be composed of any soil, although most seasoned dirt racers probably consider a moist, properly prepared clay oval their favorite dirt racing surface. Preparing a dirt track correctly for racing is both a traditional learned craft as well as a long and complex job requiring hours of work. Typical machines used in track preparation include a grader, a cultivator or rototiller, 2 types of rollers and a watering truck, although the process varies at different dirt tracks around the world. After an event, a track's rutted surface is first graded and smoothed back into the contours of the track's layout. then further smooth and tamp loose soil shoveled into any soft spots. The freshly smoothed track surface is then aerated with a cultivator or rototiller to loosen the now-compacted upper layer and assist with greater water penetration for a moister track on race day. Watering is repeated as necessary according to climate, location and soil composition. Using offset boom nozzles to on water trucks will avoid mashing aerated soil. A dirt track should be rolled and watered as required on race morning with a final light watering, just prior to wheel-packing. Outdoor dirt tracks are typically aerated 12" deep. 1
North America
Nearly all tracks are oval and less than 1-mile (1.6 km) in length with most being 1⁄2 mile (800 m) or less. The most common increments in the U.S. are 1⁄2 mile (800 m), 3⁄8 mile (600 m), 1⁄3 mile (540 m), 1⁄4 mile (400 m), and 1⁄8 mile (200 m). With the longer tracks, the race cars achieve higher speeds up to 160 mph (260 km/h) and the intervals between cars increase. This decreases the chance of crashes but increases the damage and chance of injury when cars do crash. 1
United Kingdom
In Great Britain the oval tracks are normally on grass with lengths of 400 meters (¼ mile) to 800 meters (½ mile). The races consist of several four lap qualifying heats that eliminate slower drivers. Then there is a final race featuring the fastest competitors. 1
Europe
In mainland Europe, long tracks can be grass, sand or cinder, and can be up to 1-kilometer (0.62 mi) long. 1
Australia
Dirt track racing in Australia has a history dating back to the 1920s and 1930s. Most oval track speedways are similar to those in the US for car racing such as sprint cars, speedcars (midgets) and sedans, with most tracks generally around 1⁄4 to 1⁄3 mile (400 to 540 m) in length. Most tracks have a clay surface, though some use dolomite, dolomite and clay mix or even sand and clay mix. During the 1970s and early 1980s, a small number of tracks were paved with asphalt, though this phase only lasted about a decade and all tracks paved over eventually reverted to their former surfaces. 1
The text above is adapted from the Wikipedia article “Dirt track racing”, available under the Creative Commons Attribution-ShareAlike 4.0 licence. 1
dirt track racing is form of motorsport held on clay or dirt surfaced oval race tracks, according to the structured record cited below. This entry was generated automatically from that record and has not yet been reviewed by a person familiar with the tradition. 2
The source record links this tradition to 6 external registers, which can be verified through the citation. 2





