The tradition & historical record
5 min read · 11 sourcesMountain bike trials, also known as observed trials, is a discipline of mountain biking in which the rider attempts to pass through an obstacle course without setting foot to ground. Derived from motorcycle trials, it originated in Catalonia, Spain as trialsín (from trial sin motor, "motorcycle trials without an engine") and is said to have been invented by Pere Pi, the father of Ot Pi, a world champion motorcycle trials rider. Pi's father had wanted his son to learn motorcycle trials by practicing on an ordinary bicycle. Trials riding is an extreme test of bicycle handling skills, over many of obstacles, both natural and man-made. It now has a strong – though small – following worldwide, though it is still primarily a European sport. Skills taken from trials riding can be used practically on any bicycle for balance, for example controlled braking and track standing, or balancing on the bike without putting a foot down. Competition trial bikes are characterized by powerful brakes, wide handlebars, lightweight parts, single-speed low gearing, low tire pressures with a thick rear tire, distinctive frame geometry, and usually no seat. 1
Rules
The general principle in a bike trials competition is to ride a number of pre-marked sections (usually two laps of ten sections or three laps of seven sections), the winner being the rider with the fewest points at the end of the competition. Currently there are two official types of competition rules, enforced by the UCI and BikeTrial International Union. The maximum number of points that can be obtained in each section is 5, the lowest (and best) score is 0 points or 'clean'. The most common way to gain a point is by putting a foot down within a section; for this reason points are sometimes known as 'dabs'. Certain rules enforce the number of points gained within a section, for example, putting both feet down or a hand will result in 5 points. Exceeding the time limit for the course will either result in 5 points (BIU rules) or an additional point for every 15 seconds over the limit (UCI rules). 1
UCI
Within UCI rules, if any part of the bike except the tires touch any object in the course, a dab will be given. The UCI rules were changed to this format after too many competitions ended in a draw and riders were forced to ride an extra section. UCI rules also allows riders to compete in both mod and stock categories. When a rider is in a section, neither tire is allowed to cross the side boundary tape even if the wheel is in the air. The rider's hands must remain on the handlebars. Before beginning a section, a rider is allowed to walk through it, and examine all the elements, but must not enter it with their bike. The UCI Urban Cycling World Championships are held annually and crown a 20-inch and 26-inch wheel trials world champion. 1
BIU
The rules are unlike UCI scoring and parts of the bike (for example, bash guard or bash ring, cranks and pedals) can rest on an object without resulting in a 'dab'. 1
Interscolar
The rules are the same as the "BIU" but only people belonging to a club or school can compete in these, these are for lower level students to learn how to compete. 1
Frames
Trials bikes are often designed without regard for attaching a seat. Competition riding does not require the rider to sit down and the omission allows for a lighter bike which interferes less with the body movements of the rider. For the same reason most trials frames are as low as possible, often to such a degree that at top dead centre, the pedals are higher than the frame is above the bottom bracket (BB). In terms of geometry, trials frames, especially those biased towards competition, tend to have BB spindles positioned significantly higher than the line between the axles. BB rise is one of the significant dimensions used in describing a trials frame with rises between 30 and 75 mm being common in 26″ frames. Many competition style 24″ frames aim to place the BB at the same height relative to the ground as a 26″ frame and so have a BB rise 25 mm (1″) more than a similar feeling 26″ frame. Street riding biased 24 and 26″ frames tend to have lower BB's than competition frames. Trials frames will often have holes in the front of the head tube and elsewhere such as the BB shell, the seat tube and the dropouts to reduce frame weight. This feature is not commonly seen in mountain bikes, mostly due to mountain bikes' increased exposure to mud and dust and the attendant maintenance problems having an easy route for dirt to take into the headset and BB particularly will cause. The disc brake mounts on trials frames will be more heavily reinforced than those on normal mountain bikes as trials riding routinely requires much higher brake forces than seen in mountain bike riding, especially forces acting backwards on the rear brake. Unlike virtually all other off-road bike frames in production, trials frames, especially stock frames are sometimes made without disk mounts. 1
The text above is adapted from the Wikipedia article “Mountain bike trials”, available under the Creative Commons Attribution-ShareAlike 4.0 licence. 1
mountain bike trials is sport in which a mountain bike rider attempts to pass through an obstacle course without setting foot to ground, according to the structured record cited below. This entry was generated automatically from that record and has not yet been reviewed by a person familiar with the tradition. 2
The source record links this tradition to 7 external registers, which can be verified through the citation. 2





